Dual and single switches [duplicate]

1

L1 is line, N is the neutral, PE is protective earth. ... What is the difference between a single pole and dual pole light switch? Switch Basics; Switch Basics ... A single-pole, single-throw (SPST) switch is as simple as it gets. How do you wire a double pole light switch? The Leviton 15-Amp Light Almond Double Decora Combination Rocker Switch changes every interior from traditional to modern. Its got one output and one input. Introduction This section covers do it yourself wiring of a basic single-pole switch. How To Install A Double Pole Switch. This simple how-to will have you turning lights on and off in no time. ... What is the difference between a single pole and a double pole circuit breaker? ... With the switch, you get a wiring diagram. A double-pole switch has two connectors (poles) that can control two circuits. Is it OK to install double pole light switches to replace single pole light switches wired together? Learn how easy it is to wire a single-pole switch....

0 0
2

This is a short follow-up thread after

http://www.eevblog.com/forum/microcontrollers/machxo3-mipi-csi2-pair-input-connected-to-mipi-csi2-pair-output/

With a Lattice MachXO3L, it's possible to "bridge", "switch", "duplicate" and "merge" CSI2 camera signals.

- bridge: this consist of a SPST, single pole - single throw. The camera signal is received in the FPGA and outputs. This enables for instance to modify the content of the frame.

- switch: this consists of a SPDT, single pole - double throw. It's equivalent to Fairchild FSA642 (https://www.fairchildsemi.com/products/analog-mixed-signal/switches/mipi-switches/FSA642.html), except it's digital and not analogic (see below). This enables for instance to have two CSI2 cameras linked to a single CSI2 processor input and switch between the two cameras.

- duplicate: this consists of receiving a single CSI2 camera signal and outputs it identically to 2 processors. For instance, you might want to have one...

0 0
3
Popular Dual Switch-Buy Cheap Dual Switch lots from China Dual Switch suppliers on Aliexpress.com Popular dual switch of Good Quality and at Affordable Prices You can Buy on AliExpress. We believe in helping you find the product that is right for you. AliExpress carries wide variety of products, so you can find just what you’re looking for – and maybe something you never even imagined along the way. If you are interested in dual switch, AliExpress has found 9,630 related results, so you can compare and shop! Try finding the one that is right for you by choosing the price range, brand, or specifications that meet your needs. Our selection of brands is always growing, so chances are your favorite is on AliExpress. You will find a high quality dual switch at an affordable price from brands...
0 0
4

I do believe thats true - since hyper threading does share some elements - specifically the main execution resources, you'll be able to run 4 full threads at once, rather than waiting for those resources to be freed up.

The point of HT is to get better performance with a smaller use of die area - your quad core would generally be a bigger chip - say almost twice as large, than a non HT dual core chip, while a HT dual core chip would be about 5% larger. The Quad core could see up to twice the speed under the right work load (though, unlikely since you probably won't be running 4 threads at full capacity in most cases), while the dual core HT processor would see 15-30% better performance (according to wikipedia) than a dual core non HT processor.

More actual cores is usually...

0 0
5

If you have a very large broadcast domains then think about segmenting it either with vlan's or using a layer 3 switch. You'll be able to put all your AP's onto one vlan and associate end stations with function. You'll also cut-down on broadcast flooding on your switches, thus increasing performance and lowing the possibility that one end station can dos your entire LAN.

Vlan's are powerful stuff, if you have fairly good/modern switches they should support vlans, they just need configuring.

You'll be able to implement a better security policy too.

Was the duplicate IP a configuration problem? or a security problem ;-) .

Segment that lan, before it becomes a monster.

Once you have you vlan's up and going and have regained control of your network, you can look at technologies to prevent ip address...

0 0
6

First you need to start by assembling the components onto your solar panel, or breadboard. The LDRs (light dependent resistors) or PRs (photo-resistors) change resistance with changing light, therefore they need to be connected in such a way that the changing resistance is converted into a changing voltage signal which the Arduino understands. The servo is controlled through one of the Arduino's PWM outputs.

If you are going to be installing the solar tracker permanently then you may want to solder the resistors and LDRs together so that they cannot come loose. If you are simply trying this project for fun then a breadboard is perfect.

The basic circuit for the connection of the LDRs and servo to the Arduino is shown in the attached image.

The resistors R1 and R2 are each 4.7K, the PR1 and PR2 are the two LDRs and the servo can be any PWM hobby servo. If you are using a servo larger than 9 grams then the Arduino will probably not be able to supply it enough...

0 0
7
...
0 0
8

The DES-1210 Series Fast Ethernet Smart Managed Switches consists of:

DES-1210-08P: 8-Port Fast Ethernet PoE Smart Managed Switch (8 x PoE ports, fanless) DES-1210-28: 24-Port Fast Ethernet Smart Managed Switch with 4 Gigabit Ethernet ports (including 2 Combo SFP) (fanless) DES-1210-28P: 24-Port Fast Ethernet PoE Smart Managed Switch with 4 Gigabit Ethernet ports (including 2 Combo SFP) (24 x PoE ports, smart fans) DES-1210-52: 48-Port Fast Ethernet Smart Managed Switch with 4 Gigabit Ethernet ports (including 2 Combo SFP) (fanless)

The DES-1210 Series Fast Ethernet Smart Managed Switches are equipped with 8, 24, or 48 10/100 Mbps ports, 2 10/100/1000BASE-T ports, and 2 combo 10/100/1000BASE-T/SFP ports. The DES-1210 Series integrates advanced management and security functions for enhanced performance and scalability. Support for IPv6 management and configuration ensures your network investment stays protected after upgrading from IPv4. The DES-1210-08P/28P are IEEE...

0 0
9

Note: A bug in the GPS software inverted the overall and moving averages.

After this paragraph, you’ll have the chance to read nearly 6,300 words about the fastest transcontinental drive in history. Most of the important stuff is near the top; the rest of it is a detail-oriented interview with Alex for the community of fans across the country who live and die for this sort of thing. A personal disclaimer: In my opinion, having the “transcontinental record” is an accomplishment roughly on the same level as having the most awesome fox suit at a furry convention. But TTAC isn’t a charity. It’s a business. And we need those sweet, sweet clicks. Integrity? What’s that? — jb

“I’ve always said I’d never do this again, but as a minor Bond villain put it, never say never.”

So says Alex Roy – the Doctor Evil of illegal long-distance driving events. According to Roy, women want him, and men want to be him. According to actual women, he’s got a great scarf...

0 0