Questions about: home-automation

I recently had a 3-way replaced with a Z-wave combination from Leviton (R02-DZS15 and VP0SR-10Z). The switch requires constant communication with the hub and thus needs power. If you look carefully at the wiring diagram for the Z-wave switches, you w
When you create a table in a OneNote notebook, you may want to move that table…around and you may even want to move the contents of the table around. …So that's what we're going to do right now with our TwoTrees6 notebook in the…AGM section with the
МІНІСТЕРСТВО ОСВІТИ І НАУКИ УКРАЇНИ УКРАЇНСЬКА ІНЖЕНЕРНО-ПЕДАГОГІЧНА АКАДЕМІЯ КАФЕДРА ІНОЗЕМНИХ МОВ Навчально-методичний посібник для проведення практичних занять з англійської мови зі студентами ІІ курсу заочної форми навчання для інженерних та інже
The new Philips Hue compatible dimmer switch is the next special product to make use of your Hue Lamps in your home. It’s also the cheapest accessory you can get, from Philips that will enhance your smart hue lighting project. Most of us seemed confu
I need help identifying wires to know if I have what I need to install some new light switches that require line, load, neutral and ground connections. I'm hoping to do this with a multimeter, but I am unsure what to make of the measurements. If that
Resetting the systemThe whole system, ie remote control and window with electrical products, can be reset to its initial state. To reinstate the connection between remote control and window after reset, please refer to the instructions in section Ini
This is my first post here so I won't take offense in any restructuring, closing, migrating. .
I've spent the last couple hours trying to install a smart switch in my new-construction home (finished last month in Chicago) and I'm a bit confused. Pictures here, going to focus on the top picture. The yellows/purple are loads and travelers
Old 3-way switches should have 3 wires running between them - two messengers and the return. While this isn't always possible depending on where power was fed to the circuit, my preferred way is to re-task them to be always-hot, switched-hot, and neu