How to mount handrail to drywall over concrete

1

i am assuming that the situation you are describing is drywall on furring strips on concrete (so there is a 3/4" or so gap between the drywall and the concrete). if its drywall directly on concrete, see the first answer. if its the latter than see below.

the issue is always with a railing the loading of the railing on the brackets causes crushing of the drywall and eventual destruction of the gypsum. if its over a stud, this is not too bad and repairable, but if over a void, then eventually the bracket punches a hole. a good tip for this is to mark out your bracket locations and then trace the actual bracket mounting flanges. in the center of the flange (not where the screws will go) drill a 1/2" hole in the drywall. mix up some unsanded tile grout into a firm but still fluid mixture an inject into the hole with a sausage gun (or a ziploc bag with a corner cut out of it in a pinch). squeeze a large amount into the hole (500ml) and leave to cure for a day. this will leave a...

0 0
2

how to install aluminum railing on concrete

... Craig needed to install a railing on the front concrete steps on a property he was flipping. I have a rod iron railing that is set in concrete, is there a way to install the aluminum railing into the existing concrete? My house was built in 1955 and has a concrete deck off the back. 3). Install 44 ... porch railing. how to install a railing in concrete. Install the Stair Railing ... Aluminum brackets screw to post or wall providing a ... You can also attach railing to a concrete surface How to Build a 2x4 Deck Rail on a Concrete ... a 24 Deck Rail on a Concrete Patio Part 1. ... best method to install iron railing posts in concrete? Learn how to install your handrail and more in this detailed project! ... flooring before building the railing. Thank you for choosing the durability and strength of our Weatherables Vinyl Railing! Whenever you are installing aluminum porch railing into concrete, there are a few things that you...

0 0
3

A fascia mount system is a safe and space-saving way to install a railing on a concrete porch.

Concrete is tough–and not just as a material. It’s tough because it can also be difficult to work with. After it’s laid, your options for adding onto it can be a bit limited unless you plan in advance. Usually, when a concrete porch and railing are done, they’re done together. However, if you find you need to add a railing after the fact, you have a couple options, including a fascia mount and a surface mount.

Fascia mounting is a way of mounting the railing to the side of the porch, while surface mounting is installing the railing posts directly to the surface of your porch. In some cases, it might be possible to do a surface mount on a concrete porch, especially if you’re working with hardware specifically designed for concrete. However, a fascia mount is often the best solution for this type of situation. First, though, you’ll need to start with some specific tools.

...
0 0
4

attaching stairs to concrete block wall

Spiral Stairs; Home Deck Building Tutorials 4. Dressing up a block wall with stone-veneer panels, ... How to Resurface Worn Concrete; How to Do Fall Furnace ... Tools List for Covering a Concrete Wall Concrete screws (tapcons or similar) on the concrete side, and wood screws on the framed side. 0. How to Anchor Stairs. I am thinking about 1/2" threaded rods embedded and To attach your railing to concrete you will need a hammer drill to drill into the concrete, a standard drill for drilling into the pipe, an Allen wrench to tighten the fittings, a hammer, a tape measure, hack saw, vacuum, extension cord, and a sharpie marker. Concrete screws Best for attaching furring ... concrete block and masonry. Ledger Board Attachment to a Solid Concrete ... and set into the wall at least 2-1/2. Ledger Board Attachment to a Solid Concrete ... and set into the wall at least 2-1/2. Build a 4' privacy fence on a concrete retaining wall with good...

0 0
5

When faced with old, damaged plaster walls, one technique to dress up the room is to install drywall over the existing plaster. A drywall overlay gives the walls a smooth, fresh surface that’s ready for new paint, paper or trim.

This is a common technique used among professional contractors hired to renovate houses bought under foreclosure. For example, real estate companies that invest in foreclosures often deal with houses that are more than 50 years old and exhibit serious signs of aging. The high cost of installing new plaster, or demolishing the existing walls, drives many such companies to hire contractors to overlay drywall as a practical, economical and attractive means to update the home.

First Things First

Before jumping into the project, be aware of a couple of side effects of a drywall overlay. The thickness of the drywall material will make the walls encroach into the room. This means the edges of woodwork such as crown molding, door jambs...

0 0
6

Cement block walls are common, particularly for basement construction and garages, but they lack warmth or personality. Even in so-called finished basements, the walls are often left bare. Drywall is one solution. It insulates the wall, gives it a cozy and classy look, and offers endless decorating options. There's just one drawback: Concrete and cinder blocks are porous, meaning moisture travels through like oil up a lamp wick. Attaching drywall directly to block is looking for trouble; it will eventually mildew, mold and ruin. The professional way to install drywall in these situations is to create a wood frame, of either 2-by-4 studs or thinner furring strips, and then hang the drywall. Furring strips are cheaper and take less of your living space.

Prepping the Block Walls

Measure across a wall, both at the top and bottom. Make marks at either every 16 inches or every 24 inches. These correspond to the typical width between wood studs inside a wall. For best...

0 0
7

However, how you go about fixing it depends on the type of material it is attached to. If the handrail is for an indoor staircase and is attached to drywall, you must make some basic repairs to the drywall before rehanging the handrail. Luckily, with a few simple materials and a little know-how, this is not a hard job.

Step 1

Take the handrail off the wall by using a screwdriver to remove the screws. If the staircase is longer than 6 feet, have someone help hold the handrail once each section of screws is removed. Without assistance, you risk further damaging the wall by causing the handrail to pull too hard from the remaining screws.

Step 2

Remove any loose drywall material from the screw holes on the wall. With a small putty knife, gently scrape the area so that nothing is left but strong material to work with.

Step 3

Insert quick-setting joint compound into the damaged areas and screw holes with a small putty knife. If the hole is...

0 0
8

Step 1: Run a drainpipe under the concrete floor

Shower stall on concrete

A shower usually requires a 2-in. drain, with the P-trap located under the concrete slab.

If you want to install a shower over a concrete floor, a fiberglass shower stall will work just fine. Ideally, you’ll already have a drain roughed in, with the pipe sticking a few inches above the floor. Otherwise you have to break through the concrete to run a new line.

If you have a pipe stubbed up, call the plumber or contractor who did the work to confirm it. The 2-in. pipe is typically the shower or tub drain. Line it up exactly with the drain hole in the bottom of your shower bay. This position determines the location of the stud walls around the shower. The supplier may be able to provide a dimensioned drawing of the shower bay, so you don’t actually have to put it in first.

If the existing 2-in. drainpipe isn’t where you want it, you’ll have to break up the concrete and...

0 0
9
Its very difficult to do that. If you get lucky, you may only tear off the paper of the drywall. Sometimes you can go over this with a skim coat of mud.

Since you are doing work in the Kitchen. I would recommend replacing the drywall with something more suitable for that environment. They make water resistant drywall, or better yet, cementitious underlayment.

This will give you a nice, smooth surface to start from when you go to put the new tile in, and should there be a water leak or crack in the grout - the water wont damage what's underneath.

If you want to try to save your drywall, they do make it in 1/4" but this my throw off some of the dimensions for cabinets, etc. Make sure you check first. And use a skim coat of mud underneath first, so the original damaged drywall is nice and smooth.

Good...

0 0
10
...
0 0
11

Hi, I wanted to run this procedure by the experts here to make sure I'm not forgetting anything. I am renting a house and to older folks, and when I remodeled my basement, I didn't put a hand rail back in. The basement stairs go straight down all the way and then you walk off the staircase to the right. The right side wall is opened up, and opens at the 2nd stair from the top.

The staircase runs right next to the poured concrete wall on the left.

I am going to install a short hand rail at the top 2-3 stairs on the right, but then will have to install a much longer hand rail on the left side that will go right into the concrete.

Because there was literally no space between the staircase and concrete wall, I couldn't use 2x4s to hang drywall, otherwise it would have overhung the staircase and looked dumb. So, I liquid nailed furring strips to the concrete, and hung drywall that way. I also liquid nailed foam insulation.

So, what i plan to do is use...

0 0
12

How to Attach a Wooden Railing to a Concrete Porch

Attaching a wooden railing to a concrete porch adds a touch of elegance. Many people are ... Base to Concrete · How to Install a Post on Top of Old Concrete...

...

How to Anchor a Handrail to Concrete (6 Steps) | eHow

Installing the handrail yourself will help minimize the cost. ... Mark the holes in the foot brackets onto the concrete so you know where to drill. Remove the rail and...

...

15 Customer Railing Examples for Concrete Steps

... easy to add a railing to already existing structures like a concrete wall or steps. ... After meaning to install a railing outside on his front porch for some time now,...

...

How to Build a 2x4 Deck Rail on a Concrete Patio - Part 3

Build a Deck Rail on a Concrete Patio: Install the Bottom Rail .... If your concrete deck lacks pre-existing support posts to secure the top deck rails, ... Wall Bracket.

...
...
0 0
13

Are you forced to put the drywall directly on the concrete wall or do you have at least a little bit of play to add strapping??? Especially on a basement wall wouldn't suggest applying drywall directly to the foundation wall (could end up with a bad moisture issue even with green board not to mention any movement that might occur)... At the very least you would need a vapour barrier!!!

I've on many occasions had to install drywall on a concrete or cinder block wall (but never in a basement). And usually I was able to at least use strapping (3/4" plywood or furring bar). On a couple installs (on the outside of elevator shafts, etc..) we have installed drywall directly on the concrete using construction adhesive and minimal use of Tapcon concrete screws. But there wasn't a moisture issue (like you might encounter in a basement)...

Would hate to see you go through a bunch of hard work only to get called back a few months later. The client you're working with has to...

0 0
14

Installing a staircase handrail on plaster and lath walls requires a slightly different approach than drywall. The combined thickness of three-coat plaster and lath can be 1 inch or more; drywall is usually 3/4-inch-thick or less. Screws that come with the handrail mounting brackets might be too short to penetrate deep enough into the wall studs, and care must be taken to prevent cracked plaster. If the bracket screws are 2 inches long or shorter, replace them with 2 1/2- to 3-inch screws. You will likely need a helper for this project.

Measure from the top of the stair treads up the wall to a height of 34 to 36 inches and make a light pencil mark on the wall at each measurement. This is the rough placement guide for the handrail.

Apply a long strip of painter’s tape along the wall, aligning the top edge of the tape with the pencil marks. The tape mimics the position of the rail, which helps you align the rail.

Locate the wall studs with an electronic stud...

0 0