Questions about: light-fixture

The Tospo is a cheap Chinese ballast. To find ballasts, start with what bulbs will fit in the fixture (all the better if you have a bulb already). Then search for ballasts meant to drive that bulb (which also fit in your fixture)
I'm considering replacing an outdoor lighting fixture with an LED motion-sensitive fixture, but I'm not sure how to safely do the wiring. The location is protected (under a porch) but still needs to be weatherproof. Here's the existing fixture and mo
I have recently moved into a new property and all light fittings came with no shaders/were pretty basic. I have then proceeded to (safely) remove the light fitting of the living room, replaced it with a proper pendant lamp, and reattached it. It work
Just looking the fixture itself, and giving the probability of other points of failure. .
A friend of mine was asked to repair a Harbor Breeze ceiling fan. He was told that the pull chain for the fan switch had pulled out and was missing. When he opened it up, it was true that the chain for the fan switch had pulled out
Usually the two wires that go to the wall switch are used to break the load, (switch the power (COMMON) OFF and ON to the fan). The other wires in the ceiling box are the supply wires. You need to look at the wires and find the pair that are LIVE, th
I recently installed a Minka Aire Java ceiling fan (F753-WHF) which came with a 3 speed remote controller, but which I installed with a Minka Aire hard-wired 4 speed wall control (WC105). The fan appears to work fine on all 4 speeds, but now that I'v
How To Install A Ceiling Light Without Existing Wiring Nilza Over The Sink Would Be Lighting Fixtures Kitchen And How To Install A Ceiling Light Without Existing Wiring Nilza How To Replace A Light Fixture With Ceiling Fan Tos Diy How To Replace A Li
This was my fix, my machine that would error out with DC/UC codes. I just did a repair on my FAV6800AAW by lubricating the needle bearings in the clutch pulley hub, the tub displacement sensor checked OK per the service manual check. I was getting dc
With a tape measure, measure the diameter of the ceiling opening. This is important because it will determine which type of recessed light you should buy. What If the Opening Is Too Small? As expected, it's easiest to purchase a light that exactly fi