Water not reaching the overhead tank from mains pipe- flow ground to top to the overhead tank

1

Just like all the other things, overhead tank should also be placed according to vastu. Explore vaastu tips & guidelines for overhead tank.

Overhead tanks are an important feature of a building or a house. The water that is stored in the well or the borewell has to be pumped into the overhead tank, in order for it to be able to flow down into the house. According to vastu shastra, there are some set principles that should be followed during the construction of water sump in a building. The ancient sages had founded these principles and it is considered a science or an extension of architecture. If the water tank is placed in the right area, it would definitely lead to an increase in wealth, prosperity and knowledge. To get tips and guidelines about vasthu for overhead tank, read through the following lines.

Vaastu Tips For Overhead...

0 0
2

Condensation on a toilet can be so severe that you may think it's sprung a leak, and the water can seep through...

If your Kohler toilet is running, it's doing more than wasting water--it's also running up a sky-high utility bill. Most of the...

A toilet that keeps running can be a loud annoyance that keeps you up at night and a costly water waster. Fixing...

Low flow toilets are more efficient in their water use than traditional models, but they may be more prone to flushing problems....

Well water often has an elevated mineral content, with iron high on that list. High levels of iron in water can leave...

A toilet tank that trickles water slowly not only can create an annoying sound, but it also wastes water and increases your...

A toilet receives its water supply via a water supply hose, which is attached to the shut-off valve on the left side...

If your toilet tank won't stop filling when you flush it, then it...

0 0
3

Hotel 135 lit. Overhead Restaurant need 7 liter.

(a) Overhead storage tanks are needed to build pressure of water

If the pressure of water is not sufficient, water is first stored at the ground tank from where it is pumped to the top storage tank.

Storage tank can be filled directly by means of pump also

A storage tank can be made of -

1) Mild steel plates, Aluminum plates

2) Reinforced cement concrete

3) Stones/bricks

4) HDPE

Masonry/Concrete Storage Tanks -

Tanks constructed out of reinforced cement concrete, Ferro-cement bricks stones or concrete blocks are common as they can be constructed in any shape and size to fit the site requirements. The tanks have to be made water-tight by adding a water proofing compound added to the concrete and plaster mix. All inlets outlets, etc. must be inserted at the time of construction.

Any other plastic material, etc.

A storage tank consists of...

0 0
4
Alibaba.com offers 417 overhead water tank products. About 60% of these are water treatment, 2% are chemical storage equipment, and 1% are water filters. A wide variety of overhead water tank options are available to you, such as free samples. There are 416 overhead water tank suppliers, mainly located in Asia. The top supplying countries are China (Mainland), United Arab Emirates, and Nigeria, which supply 93%, 4%, and 1% of overhead water tank respectively. Overhead water tank products are most popular in Domestic Market, Africa, and Southeast Asia. You can ensure product safety by selecting from certified suppliers, including 83 with ISO9001, 69 with Other, and 34 with ISO14001...
0 0
5

Now time to put the compiled circuit in a small box. Here i chose a Junction box that are used in electrical wiring. It was a perfect box for this project.
Now the tricky part is making holes in the plastic junction box so that LED can easily slip through the holes, also the spacing between the LED's should be proportionate. First take the box and draw the outline in the face of the box. First for the switch you should make a marking at the bottom right hand side. Then mark the points for the LED's. As told earlier it should be proportionate. Now unbend a paper clip and heat it with a soldering iron and make holes to the marked points as shown in the figure.

Then cut the plastic board for the power switch. After the cut is made file at the edges so that the cut is smooth and the switch can easily fit to into the cut. Fit in the Power Switch.

Time for adding the LED's to the panel. Let's start by adding the Red LED from the bottom end. Then to the Yellow and...

0 0
6

Short Answer: Conductivity in salt water and tap water is the result of movement of charges (positive and negative) which are ions in the liquid. This is different than electr…ons moving in wires. Salt water has more ions than tap water, so more charge carriers and more conductivity. Longer Answer: The electrical conductivity of water, whether in its pure form or with dissolved ions like salt, is explained as the movement of charged ions and not in terms of transport of nearly-free electrons as would be the case for a metal wire. With the application of a voltage, the electric field created in the liquid exerts a force on the ions, opposite directions for positives and negatives, and since this is a liquid, the ions move with relative ease. (Far less ease than electrons in a metal but far more than atoms in a solid.) Movement of these charges is the electrical current one measures. A lot of charges will result in a lot of current or a higher conductivity. In pure water, the ions...

0 0
7
Vastu Shastra

has laid down several principles for the placement of Overhead Water Tank in a flat or building. Vastu Shastra, as ancient science of architecture and construction, which dates back to the

Vedic Period

, suggests various guidelines and rules to attain success, happiness, prosperity in a household. Mental peace and spiritual bliss can be achieved through following Vastu. Overhead Water Tank is an important aspect in a house or building as it provides flowing water for drinking and other purposes. Thus the rules of Vastu should be followed while installing overhead water tank as it would bring knowledge, wealth and success.

* The overhead water tank should be located in the west or the south-west direction of the building.

* The overhead water tank in this direction should be at least 2 feet above the topmost slab. The water tank should not touch the slab.

* The overhead water tank should not leak or seep water. Dampness and wetness in the...

0 0
8

The circuit idea presented here shows a simple method by which insufficient water conditions inside an underground tank can be sensed without introducing probes inside the underground tank, and thus preventing any possibility of motor dry running. The circuit also incorporates an overhead water overflow control feature. The idea was requested by one of the interested readers of this blog.

Technical Specifications

Sir,
Do you have any idea of how to sense dry run motor by checking at the overhead tank inlet without checking at the underground tank since it takes more work in getting the wire from underground to motor place.

My requirement is motor should go off if no water is flowing at the tank inlet. Also motor should not off initially since it will take at least 5 seconds to push the water at the tank inlet.

My requirement is to switch off the motor when motor is not able to pump the water. This may be due to water level become less than...

0 0
9

Water tank vastu ensures that water tanks in your home are as per vastu shastra and aren’t bringing-in ill effects to the residents. Water tanks have different effects – and behave differently when located at different places. The effect – or ill-effect – of water tanks depends upon where it’s located with respect to the house. Hence it’s important to locate them as per vastu shastra and water tank vastu helps us achieve just that.

Now, in a house, a water tank can be located via 2 ways:

Underground – the ones that are dug up Overhead or roof top – The ones that are placed on the roof

For both types of water tanks (underground and overhead) vastu shastra has got rules and regulations that you need to know and implement while locating a water tank – of either type – in your home.

As said earlier, incorrectly placed water tanks – of any type – brings malefic affects to the residents of the house.

On the other hand, properly placed tanks could help attract...

0 0
10

Human, like every living creature on the Earth, is dependent on water. And because we need them in huge amount, we need to have a system of storing water in the vicinity for convenience. Since the early civilization, the storage of water used to be done exclusively in earthen pots and wells. With times, the dependency on water increased even more. Thus the need for even bigger storage space came in light. Thanks to the evolution of technology, we now have plastic water tanks in India to serve the purpose.

These plastics water tanks in India comes with a lot of options. This is true for both capacity and type. You can choose either underground or overhead type as per your choice. Let’s have a detailed glimpse at both of them before you chose the one for you.

Underground water storage tank

These are installed underground and this is a good choice for the people who wish to utilize their property to its maximum. It is ideal for storing water from rainwater...

0 0
11

Storage tanks are an integral part of an indirect water supply system, in which, water is not supplied continuously (i.e water is supplied only for few hours in a day). Because of that, it becomes necessary to store water to carry out different activities throughout the day. Storage tanks store water to meet water needs daily and even during repair works of mains, fire fighting and water cut offs.

Based on their location there are 3 types of water tanks:

(a) Overhead Water Tank:

Overhead water tanks are used for domestic water storage and commercial water storage purposes. They are generally placed over the rooftop of any house,building or apartment. These tanks circulate the water through its distributary channels or pipes to the taps. It is filled either with mains supply or from underground water tank. Water flows under gravity from it as water tank is at height of the building.

(b) Underground Water Tank:

These tanks are built/placed beneath...

0 0
12

A leaking overflow pipe is more than just an irritant. It leads to water waste and frequently damages the structure or other surfaces of your home as well. Besides, damp walls can lead to the formation of mold that requires costly remediation and can even cause health problems in the form of allergies. All of these various problems can be eliminated by fixing the leak in the overflow pipe. As the overflow can be caused by a variety of reasons, you need to examine all of the factors detailed below to identify the cause and resolve the issue.

1.Water Pressure is too High

One reason for an overflow pipe to leak is due to very high water pressure in the tank. This will force the water out of the overflow pipe constantly. To fix this problem, check the inlet valve that controls the flow of water into the tank and close it partially. This should lead to a lower water pressure and ensure that the overflow pipe does not leak any longer. Often, the inlet valve for the...

0 0
13
...
0 0
14

What is the nightmare for designers as a house nears completion? One answer is overhead water tanks! If they happened to be visible from the road, no design seems to be convincing enough. Possibly so, most house owners do not bother about how it appears, leaving it as a sore thumb rising from a beautifully designed house.

Besides the matter of aesthetics, the very idea of high-level water tanks is an energy consuming proposal. The electricity required to pump water from low levels to cities at higher plateau, then take it from ground level treatment plants to large neighbourhood water tanks demands a good share of the city electricity supply. Though the supply to individual sites is on gravity flow, imagine each building again pumping it up – the whole exercise appears to be against the natural principles of water flow. Though the story of reaching water from a far-off river to the house kitchen is exciting as a civilisation achievement, it is also a story of battling...

0 0
15

In the majority of homes, cold water enters the building via a rising main. This water is then directed to one or two of the downstairs taps where it is at full mains pressure. This direction is done using a T fitting with the other outlet of the T taking the water to a cold water tank in the loft. From there it is distributed around the house. (click here for diagram of water systems)

Regulations state that the cold water tank and indeed the cistern must have a close fitting lid to ensure that the water in these tanks or cisterns cannot be contaminated accidentally. The lid must not however, make the cold water tank or cistern airtight.

The water going into the storage tank is controlled by a float valve. The valve operates using a plastic (sometimes metal) ball which floats on the surface of the water, this is attached to an arm which is in turn attached to the valve mechanism. When the float rises, it lifts the arm which closes the valve and stops water...

0 0
16

InspectAPedia tolerates no conflicts of interest. We have no relationship with advertisers, products, or services discussed at this website.

Water tanks:

This article describes the purpose of water storage and water pressure tanks, how water tanks work, what goes wrong with the water tank (such as water tank leaks, loss of air charge, corrosion, failure to admit water) and how to fix water tank troubles.

We explain the purpose of water storage or water pressure tanks on private well systems, or in pressure boosting systems on municipal water supplies. We discuss how to diagnose & correct short cycling "on-off" of the building water pump. What is the difference between a bladder type water tank and a glass lined no-bladder water tank? How are well water tanks recycled?

We explain the different types of water tanks such as tanks using an internal bladder or diaphragm, bladderless steel, fiberglass, or plastic water tanks, and water tank pressure and air...

0 0