Questions about: water-pressure - страница 2

So yesterday I saw a 1,450 PSI electric pressure washer for around $80, and I was considering buying one to clean the rooftop. But now I'm reconsidering. So, my question is, does low water pressure actually affect the functionality of a pressure wash
We installed a Navien 240S natural gas in our house, and it is working fine. Except the short range for hot water valves in the showers. So, in other words, I need to turn shower valve almost all the way on to start the hot water
I noticed that many shower hoses are advertised as "explosion proof". Since I have never seen a shower head with a tap on it, I'd think the hose has to withstand only a fraction of the pressure that the regular plumbing would be required to withstand
My water pressure fluctuates drastically throughout the day. The well isn't water-logged. The pump seems to be working correctly
It's a matter of degree. As the pressure tank discharges, the water pressure will go down. When the pressure goes below a certain threshold, a pressure switch will turn on the pump, and the tank will start filling and raising the pressure
15. 1. If the heat transfer capacity in a heat exchanger is dropping, the following action should be taken:a)
For a given volume of water per second, the two 32mm pipes will have a lower pressure loss than the single 40mm pipe. Using the head loss calculator at http://www. engineeringtoolbox
I have asked a contractor (foundation/concrete guy) and he said he can put special mix of mortar at the corner at the end of that wall. My question is, what do you think causes the water in that section to accumulates? And do you think the contractor
A. what is the pressure at the bottom of the tote, assuming that the tote is full. Only the depth of the water matters