Wiring switched-controlled GFCI outlets outdoors

1

Here are four must-have tools if you plan to wire many switches and outlets:

Voltage tester. You can pick one up for a few bucks and use it to test for hot wires or to find a neutral. Just touch the probes between a hot and a neutral, or between two hot wires. The tester will light up if the wires are “hot.” The tester shown also tests for 240 volts.

Combination sheath and wire stripper. In addition to slots for stripping insulation from 14- and 12-gauge wire, it has slots to strip the sheathing from 14- and 12-gauge nonmetallic cable.

Voltage “sniffer.” The beauty of this tool is that you don't have to touch bare wires to see if they're hot. Just hold it near any wire or cable to see if it's energized. Use a noncontact voltage tester like this to double-check that all wires in a box are “dead” after turning off the circuit breaker.

GFCI receptacle tester. Just plug it into any GFCI outlet and the lights will indicate whether the outlet is properly...

0 0
2

Instructions on how to wire an outlet where one part is always hot and the other part is controlled by a switch; called a half hot outlet.

Many times people would like to have an outlet controlled by a switch to be able to turn on a lamp or some other device. Sometimes they have a switched outlet, but it is in the wrong location, or they would like to plug in another device that they would like to remain on all the time. A situation like this calls for a half hot outlet where a switch controls the top half of the outlet and the bottom remains hot all of the time.

Instructions

As always when working on electrical systems turn off the power to the circuit at the breaker panel or remove the fuse for older electrical systems.

If you have an outlet that is switched, you will still need to run a new wire with two hot conductors and one neutral and one ground, 12-3 or 14-3 wire. The “3” stands for 3 conductors, black, red, and white. The red wire is required to...

0 0
3

How do i connect a gfci outlet to a single pole light switch at wiring diagram

How To Wire A Gfci Outlet To A Light Switch One of many automotive repair tasks that are most challenging that a mechanic or mechanic shop may tackle will be the wiring, or rewiring of the car’s electric system. The situation primarily is the fact that every vehicle is different. While wanting to eliminate, change or repair the wiring within an car, having an exact and detailed wiring diagram is critical for the achievement of the repair work. Many times, there is a technician burdened unnecessarily because of outdated or inappropriate wiring schematics which can be provided by inappropriate sources.

These days, there are many resources that attempt to give wiring diagrams towards the technician online. Most times these providers have either imperfect or inappropriate diagrams that will potentially cost the shop lost moment, income or even probably case. A horrible automotive wiring...

0 0